Pole Dildos

[Hellbent]

I need suggestions on how to make a pole dildo. These are the didlo's mounted on a pole. Are there special dildos for this use? What do you use to attach it to the pole, etc.

[ProjectEuropa]

I need suggestions on how to make a pole dildo. These are the didlo's mounted on a pole. Are there special dildos for this use? What do you use to attach it to the pole, etc.

Take the insides out of a standard size vinyl vibrator and you end up with a vinyl sheath usually the right diameter to push onto a standard broom handle which are about one inch in diameter or buy a dowl the correct diameter.

[Ranai]

Hi and welcome, Hellbent.
This description comes with a fiction caveat, but perhaps it helps: Trish gets the shaft.

[BabySub]

Wow... this topic is fabulous (fantasies involved) and I HAVE to read that story. Thanks for the link Ranai. I don't get a lot of time for reading just now, but this is a must.

[Mobius]

Hi and welcome, Hellbent.
This description comes with a fiction caveat, but perhaps it helps: Trish gets the shaft.

Sure post a nice long story like monicas place when my toner cartridge is empty and so is my bank account. Any one out there work for an office supply store want to donate a HP 06A toner cartrige to a good home.

by happy to take knock off's. Thanks
Mobius

[csr]

I need suggestions on how to make a pole dildo. These are the didlo's mounted on a pole. Are there special dildos for this use? What do you use to attach it to the pole, etc.

Have a look at this adjustable stockade. It's obviously a commercial product, but if you look at the close-up of the dildo-holder it might give you some ideas. They've fashioned it with a rigid, flat ring (kind of like a large washer) that will fit over the flared base of most dildos, which clamps using wing nuts under the plate below. Obviously this might be hard to replicate DIY, but you find it at least inspirational.

[Ranai]

Have fun in wild Brisbane, Baby Sub and Mobius. So sorry for the temptation, Mobius. I promise you, until you have a new cartridge, like someone on 'the shaft', the story won't go away.

Hellbent, maybe you would like to post a picture of your DIY artifact in personal photography when it's finished?

[AndrewBlack]

Check these babies out too


http://www.fetish.0catch.com/stockades.htm


the standing stockade looks very makeable, I've been knocking things together for a little while with bars and bolts, and if I get a moment.....

[csr]

Check these babies out too


http://www.fetish.0catch.com/stockades.htm

Very nice!

[AndrewBlack]

I think on the pole-dildo + leg bar stockades it would be nice to have the distance between the legs adjustable too as standing upright with legs almost together would be extremely restrictive too. The girl wouldn't be able to bend forwards because of the huge, uncompromising, metal dildo. An adjustable angle on the pole where it meets the dildo would mean she could be bent into positions too. It could be locked in a position that was sensitive to how you wanted her positioned and then it would keep her there.

Anyone own anythng like this? Anybody every been put in stockades or used them?

[Hellbent]

That's kind of difficult to see. I prefer to use silicone dildos like the Tantus line. Having them interchangeable would be nice also. I assume there would have to be some form of clamping to the base of the dildo.

Have a look at this adjustable stockade. It's obviously a commercial product, but if you look at the close-up of the dildo-holder it might give you some ideas. They've fashioned it with a rigid, flat ring (kind of like a large washer) that will fit over the flared base of most dildos, which clamps using wing nuts under the plate below. Obviously this might be hard to replicate DIY, but you find it at least inspirational.

[fetish101]

check out hogtied.com for ideas on pole mounted dildos, they're always fucking women with them..

[Mobius]

Ok I have a question? You know your in truble when Mobius has a question.

This thread is about "pole" Dildos No not that kind of pole but the pole as in the ground. Mounted in concreat about 3.5" wide with a hight adjustment.

Can a woman be impaled on a "pole" Dildo deep enough that she can not get off. Yes I know that it would be very painful even dangerous. But the eternal question remains. Not having first hand experiance impaling a willing lady or unwilling for that matter. Young ladys as the owner of the equipment can it be done. The question is if the pole was high enough so when mounted on it her feet could not tuch the floor. Hands secured behind her back. One would think all she would have to do would be to lean forward and she would slip off. No applicable use may be good storage...
The closest thing that I have seen was on this thread

look here:

[slavelucy]

Not having first hand experiance impaling a willing lady or unwilling for that matter.

LOL!

i'm not sure i understand the question....the picture you posted shows a pole attached to a spreader bar..hence her feet are on the floor...but, are you asking if it is possible to impale someone on a pole with their feet of the floor? If so, i guess it's possible but dangerous...surely there'd be serious risk of injury. As for if she'd slip off if she leant forward....i'd say (and this is all based on what i imagine, not having done it) it would depend how wet etc she was....or indeed, how conscious she was by that point.

It's funny, cause i personally am not keen on the whole dildo on pole idea....and i think it could be because of some notion of falling and getting impaled, which, if you'll excuse the pun, just goes right through me. (!)Fetish101 is right that they use them on hogtied a lot...and i never much enjoy the scenes when they do. i can however very much see the appeal, even though i don't like it...the whole 'detached' element is quite humiliating.

sl