I did it!!!!! Ok all that is interested, get your drawing boards out. This is so simple to do!!!

First try going to your local pharmacy and asking them for medicine syringes. They will usually give them to you for free. Mine did anyway.

Next with a small saw, or even a steak knife, cut the end off so that you have a large opening. Use fine sand paper, or what I used was an emory board, and smooth all the rough egdes down.

I experimented a bit next to see how strong the pull was on the nipple and which end of the syringe to put against my skin. I found that if i reversed the way the plunger went in, and put the uncut side of the syringe against my skin that it had a better seal. Then i pulled my nipple up inside it... wow!!!
It worked great.

The next step is to drill some holes into the plunger neck.., place them all along the neck, for different degrees of pull or suction. Do use the smallest drill bit you can find but you will need to probably re-drill the holes a little, to open them up some more...

Now instead of using metal rods, I used tooth picks to put in the holes..This holds the plunger neck in its place and ta da..... you are finished.

I was going to send pictures tonight, but of course the batteries for the camera need to be recharged. I will also ask Canopus if it would be okay to post a demo picture... *wink wink*

Well I must say I am very pleased with the outcome. I was pricing nipple pumps and suction tubes online and it would have cost about $40-$50. These cost me absolutely nothing. I had everything I needed except the syringes, and the drugist gave those to me.

Hope I have explained this well enough. If not hopefully the pictures should help out... or just send me your questions. I will be glad to help if I can.

Have fun!!! I did!!!!!

Master's tehya